Manifolds for 2007 Chrysler Pacifica
See Important Note. 04593899AA Throttle Body Gasket Must Be Used With 04781578AP Recessed Lip. See Important Note. 04666113AA Throttle Body Gasket Must Be Used With 04781578AM Flush Lip. Includes Items 2,3,5,6,7. Includes Items 2,4,5,6,7.
Used With 04781578AM Intake Manifold Plenum Flush Lip. See Important Note. Used With 04781577AL Intake Manifold Plenum Flush Lip.
[m6x1.00x30.00]. Upper Intake Manifold To Lower Intake Manifold. Upper Intake Plenum To lower Intake. Upper Intake Plnum To Lower Intake Manifold.
Hex Head Bolt And Coned Washer, Mounting
Light Bar To Liftgate. Capacitor attaching. Ground Strap attaching. Fuel Rail Mounting. SCR Dosing Module To Exhaust Pipe. Engine Bundle Clip to Trans. Rear Brake Hose to Sill. Clip Attach. Fuel Rail To Intake Manifold. M6x16x14. [m6x1.00x16.00].
Hex Flange Head Bolt And Coned Washer, Mounting
M8x1.25x70. Lower Intake to Cylinder Head Attaching.
Sensor to intake manifold. Engine oil temp sensor. Engine coolant temperature. Oil temperature.
Nipple
Y-Style. Also Serviced With Item 1. Water Supply Rear Lower Intake. Also serviced wih Cover. Heater hose fitting. 0.375-18x2.00. Special .375-18x2.00 Heater Hose Supply. Also serviced with Cover.
Thermostat
Plastic Connector. Includes Thermostat,Seal,Water Inlet Tube and Hose.
Hex Flange Head Bolt, Mounting
M6x1.0x30.00. Front Impact Sensor. Side Impact Sensor. Clutch Slave Cylinder to Manual Transaxle. Concentric Slave To Transaxle. To Lower Intake Manifold. Water Outlet to Lower Intake. Thermostat Housing. [m6x1.0x30.0].
Bolt, Mounting
Left Exhaust Manifold to Shield. Exhaust Manifolds to Cylinder Head. M8x1.25x30.
Hex Flange Nut, Mounting
M8x1.25. ULEV Converter Attach. Converter Mounting. Front Exhaust Pipe To Elbow. Front Pipe Assembly To Exhaust Manifold. Attaching.
Hex Head Bolt And Washer, Mounting
Clutch Slave Cylinder. Alternator Pivot. Timing Cover To Engine Block. Chain Case Cover. Front Timing Cover To Cylinder Block[M8x1.25x45.00]. P/S Pump to P/S Pump Bracket Mtg. To Alternator Bracket. Front Pipe To Exhaust Manifold. Catalytic Converter to Manifold.
Hex Head Bolt And Coned Washer, Mounting, Right
M6x1.00x37.00. Heat Shield To Exhaust Manifold. Heat Shield to Right Manifold. Throttle Body mounting. Throttle Body attaching. Heat Sheild To Exhaust Manifold.
Crossover to Manifolds Attaching. M10x1.50. Crossover Pipe to Exhaust Manifold Attaching.
Hex Flange Head Bolt, Mounting
M10x1.50x43.00. Crossover To Exhaust Manifold.